BASF Filament Ultrafuse ABS Fusion+ – 1.75mm

BASF Filament Ultrafuse ABS made with Polyscope XILOYTM 3D is an engineering filament that has been optimized for 3D printing. This special grade has been developed in collaboration with Polyscope Polymers, an expert in enhancing polymer behavior with Styrene Maleic Anhydride (SMA). Polyscope is renowned for its material solutions in the automotive industry. Because of that the parts printed parts are tough, chemical and heat resistant, and have very low warping. The material is available in 3 colors. 

Ultrafuse ABS Fusion+ is an easy-to-print engineering material and enables a much more efficient printing process. Meaning 3D printing operators will spend less time tinkering and more time exploiting the full potential of your 3D printing rig. To top it off, ABS Fusion+ adheres to water-soluble support – no more hassle with chemicals, just dissolve your support in water after printing!

• high heat resistance
• direct printing on heated glass or print bed surfaces
• easy to print
• chemical resistance
• low warping
• tough material
• adheres to water-soluble support - just dissolve your support in water after printing
• ideal for engineering parts - jigs and fixtures, automotive parts
• for FFF/FDM 3D Printers 

Technical Specification

• Package size: 750g 
• Density: 1.08 g/cm3
• HDT @ 0.45 MPa: 91 °C
• Young's Modulus: 1379MPa (XY) and 1106MPa (ZX)
  
• Elongation at Break: 10.9% (XY) and 2.1% (ZX)
• Flexural Strength: 48.3MPa (XY) and 23.1MPa (ZX)
• Tensile Strength: 29.5MPa (XY) and 17.9MPa (ZX)
• Impact Strength Charpy(notched): 32.0kJ/m2 (XY) and 2.5kJ/m2 (ZX)
• Nozzle Temp: 240-260℃
• Bed Temperature: 100-120℃
• Print Speed: 40-80mm/s

• Make sure to store the filament in a dry place in tightly closed containers
• For more information please check the "Downloads" section 

Warranty

• Please visit Terms and Conditions page
• If you have any questions do not hesitate to contact us